logixpro batch mix process using all inputs

So, for the second rung (001) as you can see when the HIGH_LEVEL switch will indicate the level it will de-energize the filling pump “PUMP-(1)” and also it will latch the HEATER to increase the fluid temperature. Regarding the application AFD, PUMP-(1) should be turned ON till it fills the tank (HIGH_LEVEL energized).(3) for the first rung “000” whenever we press the START button it will energize the Latching coil for the output that is responsible to operate PUMP-(1). Now by starting with the first condition which is by pressing START, PUMP-(1) should turn on.Īs we can see in Fig.“Before we start to discuss our solution, it is very important to give it a try by yourself for just 15 min.” Now and after we have discussed and summarized the batching process operation the next step is to clarify the Input and Output signal list as followed: F unction Address START I:1/0 STOP I:1/1 HIGH-LEVEL I:1/4 LOW-LEVEL I:1/3 PUMP (1) Q:2/1 PUMP (2) Q:2/3 HEATER Q:2/4 MIXER Q:2/0 THERMOSTAT I:1/2 Translating the batching process conditions into Ladder instructionsĪlways remember that programming is not as hard as you imagine all you need is to start step by step and whenever you feel that your PLC code becomes to be complicated and not organized, be sure that you are on the wrong path. Batch Simulator using LogixPro PLC SimulatorĪs we discussed earlier in the operation of the batching process, now we are going to start with the first step by summarizing the whole application shown in Fig.

Commissioning the PLC program by downloading your code to the PLC and troubleshooting the bugs and errors, then with swift editions now your code is ready.Step by step and always remember, “start simple… and finish simple”. Start by converting the AFD to the Ladder Logic Instructions.Identifying the application Input/output signals “making an I/O list”.Clarifying the operation sequence and interlocks in the form of short and concise sentences “AFD”.

Basic steps for PLC programmingĪs we said before PLC programming does not need a talented engineer as much as it needs an organized person, here we have basic steps that we need to follow for coding any PLC application: This kind of process is commonly used in many factories with the difference in the type of material being mixed. After carrying out some industrial processes such as (heating, mixing, …) the whole mixture is ejected from the tank by a discharging pump.

Logixpro batch mix process using all inputs